Broyeur

Les pulvérisateurs sont un type de mécanisme dans Vintage Story. Il est utilisé pour broyer les minerais et les minéraux qui sont trop durs pour être réduits en poudre dans un moulin à bras.

Fabrication

Les pulvérisateurs sont constitués d'un châssis de pulvérisateur, d'un cardan de pulvérisateur et de deux pilons couronnés.

Pulverizer frames hold the entire mechanism together. It is a two-block high structure. The pulverizer toggle must be placed within a pulverizer frame. Two pounders must then be attached to the frame, and capped.

Ingrédients	Recette
Saw Rock Boards (x42)

Ingrédients	Recette
Hammer Chisel Wooden Axle Metal Plate

Ingrédients	Recette
Hammer Chisel Log

An almost-complete iron pounder cap being smithed.

Pounder caps

Pounders must be capped with a metal cap. These can be smithed out of any bronze, iron, meteoric iron or steel. Both caps must be placed at the same time, and require a stack of 2 to place. Therefore, both pulverizer caps must always be made out of the same material. The tier of the metal used for the cap will determine what materials the pulverizer can process.

Usage

Pulverizers are used to crush quartz, bauxite, olivine or ilmenite for use in refractory bricks, or for crushing cinnabar or lapis lazuli to make dyes.

Pulverizers must be powered via a windmill or similar mechanism in order to function, and cannot be manually operated.

Automated operation

Annotated pulverizer setup in Creative Mode. 1 is input, 2 is power, and 3 is output.

Pulverizers must be powered by windmills to automate crushing, for more info on power generation & power trains, see mechanical power.

Remarque : As with querns and other automated machines, its output may despawn if the player is too far away from the pulverizer as it works. Hoppers cannot fix this issue as they similarly only work while the player is in range.

• Power input: Connect a powered axle to the bottom left or right of the frame, where the pulverizer toggle is. They cannot be powered from the top or bottom.
• Input: Placing a hopper above an elbow chute leading into the front side of the frame, where the two pounders are located, will insert items into the input slots of the pulverizer. Note that a hopper drops items slowly - to speed the process up, replace the hopper with a chest directly above the elbow chute leading into the front side.
• Output: Items will automatically be thrown out the front of the frame, opposing the pounders. To collect items, a hopper can be placed under the output area and fed into a chest, or into a system of chutes to direct output to one chest. Place at the level of the block supporting the pulverizer, not next to the side of the frame block itself. If the hopper, or any block for that matter, is placed next to the back side of the pulverizer, this placement will block the normal output slot, and the items will instead be thrown out to the two blocks to the right and left of the block behind the frame block. To optimize the automated output, leave the block directly behind the lower frame block open, place blocks to the left and right and a hopper below. This way, the items thrown out cannot deviate to the side and will instead fall into the hopper.

Video Tutorials

How to build a pulverizer in version 1.14	How to automate a pulverizer