Leather working/ja

革の加工は未加工の皮を革に変えるための、樽を使った一連の特別なレシピです。

必要な素材

革を作るためには、以下の素材が必要になります。

• 皮（注意として、「巨大な」皮は現在のゲームでは手に入りません）
• 石灰かホウ砂の粉末
• タンニンを作るためのオークの原木
• 液体を移すためのバケツ（バケツには10ユニットの液体が入ります）
• 皮を加工するための樽（樽には50ユニット、バケツ5個分の液体が入ります）

皮

皮は野生または家畜の動物から、死亡時に取得することができます。以下の動物は皮をドロップする可能性があります。

• 皮（小）：ウサギ、アライグマ、キツネ、子羊
• 皮（中）：ブタ、ハイエナ、オオカミ
• 皮（大）：ヒツジ

石灰＆ホウ砂の粉末

石灰は石灰岩、チョーク、あるいは緊急時は貝殻から、クラフトグリッドでハンマーで砕くか、挽き臼で挽くことで取得できます。どちらも入手できる石灰の量は変わりませんが、ハンマーを使うと耐久性が減少し、挽き臼は繰り返し使っても損耗しません。貝殻はハンマーでは砕けず、挽き臼を使う必要があることに注意してください。
石灰は生石灰を作るためにも使え、これは石膏の生産に必要になります。

ホウ砂の粉末は石灰の代替品で、ホウ砂鉱石の大きな塊を砕いたり粉砕したりすることで得られます。石灰と同じようにハンマーか挽き臼で作ることができ、方法によって量が変わることはありません。鉱石の大きな塊ひとつで、ホウ砂の粉末2個分です。
ホウ砂の粉末は、鉄か隕鉄の金床を鍛造するプロセスにも必要な素材です。

買い物リストの例

バックパックひとつをクラフトするのに必要な革8個を加工するには、以下の素材と液体が必要になります。
液体はバケツでしか移動できず、バケツは最大10L入るので、液体の量は10の位に切り上げられることになります。巨大な皮はまだゲーム内で入手できませんが、クリエイティブモードでは手に入れることができます。

• オークの原木：皮（小）には3個、皮（中、大、巨大）には6個
• 石灰またはホウ砂の粉末：石灰かチョークの石を挽くことで石灰が得られ、ホウ砂を挽くことでホウ砂の粉末が得られます。
  • 石灰：皮（小）には8L、皮（中）には17（20）L、皮（台）には19（20）L、皮（巨大）には20L
  • ホウ砂の粉末：皮（小）には4個、皮（中、大、巨大）には8個
• 皮：皮（小）を8個、皮（中）を4個、皮（大）を3個、皮（巨大）を2個のいずれか
• 石灰水か希釈したホウ砂：皮（小）には8（10）L、皮（中）には17（20）L、皮（大）には19（20）L、皮（巨大）には20L
• 弱いタンニン：皮（小）には16（20）L、皮（中）には34（40）L、皮（大）には38（40）L、皮（巨大）には40L。この半分が強いタンニンになる
• 強いタンニン：皮（小）には8（10）L、皮（中）には17（20）L、皮（大）には19（20）L、皮（巨大）には20L

皮の加工手順

一度に小、中、大、巨大のいずれかのサイズの皮のみを加工できます。巨大、大、中、小の皮は、それぞれ10、6、4、2リットルを必要とします。 皮のサイズが異なると、加工を終えた後に入手できる革の量も変わります。巨大、大、中、小の皮は、それぞれ5、3、2、1個の革になります。

以下の表は、後述するそれぞれの加工段階で必要な溶液を1樽分作るのに必要な素材を示しています。

ベースの液体	溶媒	結果（1樽分）
水 50 L	石灰 50	石灰水
水 50 L	ホウ砂の粉末 20	希釈したホウ砂
水 50 L	オークの原木 5	弱いタンニン
弱いタンニン 50 L	オークの原木 5	強いタンニン

• 巨大な皮はゲーム内で見つかりませんが、クリエイティブモードには存在しています。

Step 1: Limewater or Diluted Borax

To make soaked hides, limewater or diluted borax may be used:

• Limewater: 1 unit/litre of water and 1 lime makes 1 unit/litres of limewater - which means a full barrel of limewater requires 50 lime.
• Diluted borax: 5 units/litres of water and 2 powdered borax make 5 units/litres of diluted borax - which means a full barrel of diluted borax requires 20 powdered borax.

To make either limewater or diluted borax, it is not required to seal the barrel or wait for a processing time. Simply add the required amount of lime or powdered borax to a barrel filled with the required amount of water - if the ratio is correct, the water will instantly change into limewater or diluted borax. If the player is unsure about the correct ratio, simply fill the barrel with the amount of water and keep adding lime or powdered borax one by one until the change happens.

Once the player has acquired the necessary lime or borax solution, the raw hides can be placed inside the barrel, after which it needs to be sealed for 20 ingame hours to turn into soaked hides. Similar to the above process, a specific ration must be reached. The player can start with one hide and check the barrel tool tip, it should display the amount of liquid solution, input hides as well as the possible output. If there is no output shown, the player placed too many hides in the barrel for the available amount of liquid.

• 

  The maximum amount of small hides in one barrel of limewater.

Step 2: Scraping Hides

Once the raw hides have been soaked long enough, they will turn into soaked hides. These can not directly be further processed in barrels - another crafting step comes in between. The player needs to put the soaked hides and a knife into the inventory crafting grid to process them into scraped hide. Please note that the knife will loose durability in the process.

Step 3: Weak Tannin

To make 10 units/ litres of weak tannin, the player needs 10 units of water and 1 oak log. After inputting the oak log, the barrel tooltip will display the materials present as well as the predicted output. The barrel must be sealed for 24 ingame hours to actually produce weak tannin - it cannot be sealed if an unbalanced ratio of water and oak logs are present in the barrel.

After the player acquired weak tanning with the above procedure, place the scraped hides into the weak tannin solution. Again, further processing of the hides requires sealing in the barrel - after 4 ingame days they will become prepared hides. Similar to the previous processes, a specific ration must be reached. The player can start with one hide and check the barrel tool tip, it should display the amount of liquid solution, input hides as well as the possible output. If there is no output shown, the player placed too many hides in the barrel for the available amount of liquid, and the player will not be able to seal it.

• 

  Weak tanning can be created from water and oak logs.

• 

  The maximum amount of small scraped hides in one barrel of weak tannin.

Step 4: Strong Tannin

To make 10 units/ litres of strong tannin, the player needs 10 units/litres of weak tannin and 1 oak log. After inputting the oak log, the barrel tooltip will display the materials present as well as the predicted output. The barrel must be sealed for 24 ingame hours to actually produce weak tannin - it cannot be sealed if an unbalanced ratio of water and oak logs are present in the barrel.

After the player acquired strong tanning with the above procedure, place the prepared hides into the strong tannin solution. Again, further processing of the hides requires sealing in the barrel - after another 4 ingame days they will become leather. Similar to the previous processes, a specific ration must be reached. The player can start with one hide and check the barrel tool tip, it should display the amount of liquid solution, input hides as well as the possible output. If there is no output shown, the player placed too many hides in the barrel for the available amount of liquid, and the player will not be able to seal it.

After waiting for the sealed hides to process, the player will be rewarded with the respective amount of leather ready to be used in crafting.

• 

  Strong tanning can be created from weak tannin and oak logs.

• 

  The maximum amount of small prepared hides in one barrel of strong tannin.

Pelt

Different from Leather, making pelts is relatively easy.

Hide curing

To create pelts, only two steps need to be followed. First, raw hides need to be oiled, this can be done by combining raw hide and fat in the crafting grid.

In a second step, these oiled hides need to be "cured", which means nothing else but leaving them untouched for a certain amount of time. There is no process involved and the storage place doesn't matter - the player can carry them around in the inventory or leave them in a storage container. The tooltip on the item will inform how much the curing has progressed. Once completely cured, the oiled hides will turn into pelts that can be used in different crafting recipes.

Usage

Pelts are currently only required for the hunter's backpack, a cheaper variant of the leather backpack with only 4 slots, as well as the Lamellar armour recipes. Keep in mind that pelt recipes only accept medium or large pelts - small pelts have no usage in the vanilla game at the moment.

Video Tutorials

Detailed explanation how to make leather

{{{title}}}